Publicité
Les langues disponibles
Les langues disponibles
STEP 4. INSTALLING
THE CONDUIT
Remove the conduit connection plate and rotate it as shown below.
The conduit hole (11/s") must be used.
1. Prepare the conduit cord as shown in Figure 1.
2. Install the conduit cord as shown in Figure 2.
Figure
1
Figure
2
3/8"
1"
3/8"
3 wire
4 wire
Knockout surface
Conduit connection plate
Strain relief
For conduit installations, insert the strain relief (not included) into the conduit hole (11/s").Then thread
the conduit cord through the body of the strain relief and fasten the ring. Reinstall the bracket.
Installing
a 3-wire conduit
• Aluminum building wire may be used but it must be rated for the correct amperage and voltage.
Connect the wires as described below.
The wire you use, the location and enclosure of splices, etc., must conform to good wiring
practices and local codes.
1,
2,
3,
4,
5,
Loosen the 3 lower terminal screws from the
terminal block.
Insert the center bare wire (white/neutral) tip
through the bottom center terminal block opening.
On certain models, the wire will need to be
inserted through the ground strap opening and
then into the bottom center block opening.
Insert the two side bare wire tips into the lower left
and the lower right terminal block openings.
Tighten the screws until the wire is firmly secured
(35 to 50 inch-lbs.). Do not over-tighten the
screws since it could damage the wires.
Go to step 5 on page 27 to continue with the
installation.
English - 26
Publicité
