Publicité
Les langues disponibles
Les langues disponibles
CHECKING
THE INSTALLATION
SITE
Clearances
and dimensions
To install the range, refer to the following figure.
A_CAUTION
This range has been designed to comply with the maximum allowable wood
CAUTION
cabinet temperatures of 194 °F. Make sure the wall covering, countertops and cabinets around the
range can withstand the heat (up to 194 °F) generated by the range, if not, discoloration, delamination
or melting may occur.
3"
,' 1/2" min.
',
2+ ++(
Hatched
Faces should
be
,
flat and leveled.
36"-3G-4/5"i23_1/5"
29-4/5"
A : Cabinet opening
29-15/16"-30-1/16"
(76.04 - 76.28 cm)
B : Acceptable
electrical
ouUet area
If your cabinet have height over 36-4/5", this range cannot be installed without supporting unit
like hard block.
Minimum
dimensions
®IM
nr "_V
RTANT
To eliminate the risk of burns or fire caused by reaching over heated
surface units, avoid having cabinet storage space located above the surface units, if you have cabinet
storage space over the heating elements, you can reduce the risk by installing a range hood that
projects horizontally a minimum of 5 inches beyond the bottom of the cabinets.
*'15"
+
_
30"
* 30"
* 30" minimum clearance between the top of
the cooking surface and the bottom of an
unprotected wood or metal cabinet; or 24"
minimum when the bottom of the wood or
metal cabinet is protected by not less than
1/4"of flame retardant millboard covered
with not less than no.28 MSG sheet steel,
0.015" stainless steel, 0.024" aluminum, or
0.020" copper.
** 15" minimum between the countertop and
the adjacent cabinet bottom.
English - 21
Publicité
