GYS GySpot Combi 230E Pro Notice D'utilisation page 10

A- Steel position (fig. I)
Connect the machine to an appropriate power supply.
Nb: Combi 230 E Pro has, in addition to the power connector, a connector to command the torch trigger:
- Connect the latter if you wish to start by using the trigger
- Disconnect it if you prefer use the generator with automatic start (see OPERATION section)
Press the « on/off » key (⑥)
The indicators switch on for few seconds then the machine displays:
• Tool, n°1 by default, (star welding or dent pulling clamp).
• Power level, n°5 by default, (setting adapted for 0.8mm steel sheets).
To change the power level, press the + or – keys (③). Keep the desired key pressed to scroll through the levels
automatically.
The available power levels allow the straightening of sheets of varying thickness (fig. I-2).
To change the tool used with the gun, press the tool selection key (I-3); the tool indicator will blink for 5 seconds.
During this time, it is possible to change the tool number by pressing the + or - keys (③).
Available tools (fig. I-3)
1 Straightening using the star hammer, or dent pulling clamp. 5 Welding rivets for side rods
2
Crimped welding wire or rings for straightening.
3
Impact reduction with specific copper tip.
4
Carbon electrode for tempering.
Start-up:
With use of the trigger
The Combi 230 E Pro features 2 start-up settings:
- Manual, by using the trigger (Attach the power and command connectors)
- Automatic, see below. (Attach only the power connector)
In manual mode, connect the power and trigger command cables.
The automatic mode is disabled, only a pressure on the trigger will generate the arc.
The switch allows activating or deactivating the trigger gun.
Without use of the trigger
The machine is able to generate the welding arc automatically.
The generator will automatically detect the electrical contact and generate the welding arc in less than 1 second. To create
a new arc, stop the contact with the gun tip for at least ½ second and establish contact again to form another arc.
Operating:
Proceed as follows:
Connect the earth clamp of the generator to the sheet metal to be straightened and follow the instructions below:
- Connect it as close as possible to the place to be welded.
- DO NOT connect it to a different part of the car body (Ex: Do not connect it on the door when working on the wing)
- Ensure the metal has been properly stripped at the connection point.
Grind the area where the metal is to be worked.
Attach the required tool to the end of the gun, tightening the nut firmly
Select the tool and the power level (see "Operating and Setting") on the machine)
Make contact between the tool on the gun and the metal.
Generate your welding arc.
Caution: For optimum operation, it is recommended to use the delivered earth cable and gun originally
6
Welding rings for fixing vehicle body.
7
Welding studs for vehicle body and connecting beams
supplied!
9