Publicité
Les langues disponibles
Les langues disponibles
Safety
2
|mportant
Safety
|nstructions
SAVE THESE INSTRUCTIONS
-This manual
contains
important
instructions
that should
be followed
during
installation,
operation,
and maintenance
of the product.
Save this manual
for future
reference.
This is the safety alert symbol.
When
you see this
symbol
on your pump or in this manual,
look for one of
the following
signal words and be alert to the potential
for personal
injury[
indicates
a hazard which,
if not avoided,
will
result in death or serious injury.
[gWAFIN[NG[
indicates
a hazard which,
if not avoided,
could
result in death or serious injury.
1_ CAUTION[ indicates
a hazard which,
if not avoided,
could
result in minor
or moderate
injury.
NOTICE
addresses practices not related to personal injury.
Carefully
read and follow
all safety instructions
in thls
manual
and on pump.
Keep safety labels in good condition.
Replace
missing or damaged
safety labels.
Electrical
Safety
I_WARNiNG]
Capacitor
voltage may be hazardous.
To discharge
motor
capacitor,
hold insulated handle
screwdriver
BY THE HANDLE
and short capacitor
terminals
together.
Do not touch
metal screwdriver
blade
or capacitor
terminals.
[f in doubt,
consult
a qualified
electrician.
General
Safety
[_, CAUTION1 Do not touch
an operating
motor.
Modern
motors
are designed
to operate
at high temperatures.
To
avoid burns when servicing
pump,
allow
it to cool for
20 minutes after shut-down
before handling.
Do not allow
pump or any system component
to freeze.
To do so will void warranty.
Pump water only with this pump.
Periodically
inspect
pump and system components.
Wear safety glasses at all times when working
on pumps.
Keep work area clean,
uncluttered
and properly
lighted;
store properly
all unused tools and equipment.
Keep visitors at a safe distance
from the work areas.
[_WARNING]
Pump body may explode
if used as a
booster pump unless relief valve capable of passing full
pump flow at 75 psi is installed.
WARNING
Hazardous voltage.
Can shock,
burn, or
cause death.
Ground pump before
connecting
to power
supply. Disconnect
power
before working on pump,
motor or tank.
_k
Wire motor
for correct
voltage.
See "Electrical"
section of this manual
and motor
nameplate.
_
round
motor
before
connecting
to power
supply.
Meet Natlona[
Electrical
Code, Canadian
Electrical
Code, and
local codes for all
wiring.
_
Follow wiring
instructions in this
manual when
connecting motor
to
power lines.
WARNING
Hazardous pressure!
Instal[ pressure
relief
valve in discharge
pipe.
Release all pressure on
system before working on
any component.
Publicité
