Installing Fittings And Locking Cylinders; Testing The Multi-Point Lock 319N - Assa Abloy OneSystem 319N Notice De Montage

Fasten the locking
cylinder with the
cylinder fixing screw
Check for complete
functionality
Fig. 6 :
No transverse shear
stress on the bolt after
installation
EN
48

Installing fittings and locking cylinders

1 Install the fittings.
2 Insert the locking cylinder and ensure that the locking cylinder nose is in the centre position (Fig. 16).
3 Fix the locking cylinder into place with the fixing screw.
 The multi-point lock 319N is completely installed.

Testing the multi-point lock 319N

1 Test all functions of the multi-point lock 319N.
2 Check whether the latch and control latch of the lock are pushed back by the same impact edge.
3 Check whether all bolts can freely extend and retract without transverse shear stress after installation
(Fig. 6).
 The multi-point lock 319N is completely installed and has been tested for functionality.
Striking plate
F
= 0
Q
N
min. 2
F
= 0
Q
N
Face plate
Installation