Intended Use - Assa Abloy OneSystem 319N Notice De Montage

Information

Intended use

The multi-point lock 319N is suitable for installation in single or double-leaf tubular frame or solid-leaf
doors (backset 55 mm or greater) made of metal or wood.
It is designed to provide door locking in security areas and is approved for use in escape doors according
to DIN EN 179 and panic door locks according to DIN EN 1125.
· With two-leaf escape doors, the inactive leaf must also be designed as an escape door and must be
equipped with an approved passive leaf lock ("Accessories", page 60).
· If the inactive leaf is not designed as an escape door, the multi-point lock 319N may only be installed in
the two-leaf door when the inactive leaf can be securely held in place with zero play and the active leaf
runs against a stop edge.
With double-leaf doors with rebated meeting stile and panic locks in each leaf, the leaf must open when
the panic door lock is actuated. Both leaves must open freely if both panic door locks are actuated at the
same time. This may require a door coordinator to be installed.
With double-leaf doors with rebated meeting stile and door closer, the correct door closing sequence
must be assured; otherwise the function of fire doors or smoke protection doors, in particular, is not
guaranteed. It may be necessary to install a follower.
It is approved for use in fire doors (smoke protection doors). All applicable provisions for the approval of
protective doors must be observed.
The multi-point lock 319N is available in a special version without escape door function. This special version
is not permitted for use in escape doors according to DIN EN 179 and panic doors according to DIN EN
1125. The special version is equipped with a continuous handle follower (continuous square spindle). The
inner and outer door handles are always engaged or disengaged simultaneously.
The lock is tamper-proof in accordance with SKG
achieve the specified SKG ®
hinges/strips, escutcheons and cylinders) must be certified to at least the equivalent standard.
The multi-point lock 319N may only be installed in properly functioning door systems. All applicable
regulations for the complete door system must be observed.
The device is suitable for installation according to the installation instructions and use according to the
functional description.
The multi-point lock 319N is suitable for installation in doors with a high usage frequency, for use by
persons with little reason to take care, where there is the possibility of an accident or misuse (such as
office doors).
It is not intended for any other type of use.
® standard (Seite 32). For the complete door lock to
intrusion protection level, all components (high-security striking plates,
EN
39