Télécharger Imprimer la page

Kenmore ELITE 110.2206 Serie Guide D'utilisation Et D'entretien page 7

Publicité

Les langues disponibles

Les langues disponibles

If codes permit and a separate ground wire is used, it is
recommended
that a qualified electrician determine that the
ground path is adequate.
Do not ground to a gas pipe,
Check with a qualified electrician if you are not sure the
washer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
GROUNDING
INSTRUCTIONS
For a grounded,
cord-connected
washer:
This washer must be grounded. In the event of a malfunction
or breakdown, grounding wilI reduce the risk of electrical
shock by providing a path of least resistance for electric
current. This washer is equipped with a cord having an
equipment-grounding
conductor and a grounding plug. The
piug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with alI local
codes and ordinances.
WARNING:
Improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance - if it wili
not fit the outlet, have a proper outlet installed by a qualified
electrician.
For a permanently
connected
washer:
This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding
terminal or lead on
the appliance.
INSTALLATION
INSTRUCTIONS
Install the rear self-adjusting
feet
1. To prevent floor damage, set the washer onto cardboard.
2. Move the washer to within approximately
3 ft (90 cm) of the
final location.
3. Prop up the rear of the washer about 4" (10.2 cm) with a
wood block or similar object. The block needs to support the
weight of the washer.
4. Install the self-adjusting
rear feet by pushing all the way up
into the hole shown below,
A
B
__
................
C
i
,/'
j
,
A. Rear panel of washer
B. Rear leveling foot
C. Hole in bottom of washer to receive rear leveling foot
D. Rear leveling foot pushed into bottom of washer
Tilt the washer forward and remove the wood block. Gently
lower the washer to the floor.
Install the front leveling feet
6. Prop up the front of the washer about 4" (10.2 cm) with a
wood block or similar object. The block needs to support the
weight of the washer.
7. Screw the Iocknut onto each foot to within 1" (2.5 cm) of the
base.
1 "
(2.5
cm)
Screw the feet into the correct holes at the front corner of the
washer until the nuts touch the washe£
NOTE: Do not tighten the nuts until the washer is level.
Tilt the washer back and remove the wood block. Gently
lower the washer to the floor.

Publicité

loading

Ce manuel est également adapté pour:

Elite 110.2408 serieElite 110.2506 serieElite 110.2508 serie