those described in chapter
5.2 WHY THE SAFETY DEVICES CUT IN
The safety devices work in two ways:
-- - by preventing the engine from starting if all the safety requirements have not been
met;
-- - by stopping the engine if even just one of the safety requirements is lacking.
e) The engine must only be started in the following conditions:
-- - the transmission is in ''neutral'';
-- - the blade is not engaged;
-- - the operator is seated or the parking brake is engaged.
f)
The engine stops when:
-- - the operator leaves his seat when the blade is engaged;
-- - the operator leaves his seat with a gear engaged;
-- - the grass-catcher is lifted without disengaging the blade;
-- - the blade is engaged without the grass-catcher in place;
-- - the parking brake is engaged without disengaging the blade;
-- - the speed change is activated (☛ 4.4) with the parking brake on.
5.3 PRELIMINARY OPERATIONS BEFORE STARTING WORK
These controls ensure that the work gives the best results and is done in maximum
safety.
5.3.1 Seat adjustment
Adjust the seat by sliding it along the bracket slots.
Page 125 de 160
All the references relating to the positions of controls are
4.
1. Loosen the four screws (1);
2. once you have found the right
position, securely tighten the four
screws (1).