Elem Garden Technic TRACT84-AR Traduction Des Instructions Originales page 122

4.4 SPEED CHANGE LEVER
Reverse must be engaged when the machine has stopped.
4.5 CUTTING HEIGHT ADJUSTING LEVER
4.6 KEY IGNITION SWITCH
The lever has two positions, as shown on the plate:
Page 122 de 160
This lever has six positions for the four forward
gears, the neutral position «N», and reverse «R».
-- - To change gear, press the pedal (☛4.2) halfway
down and move the lever as per the indications
on the label.
There are five positions for this lever, shown
as
«1» to «5» on the plate, which correspond to
various
cutting heights from 3.5 to 7.5 cm.
-- - To go from one position to another,
move the lever sideways and put it back in
one of the stop
notches.
《○》everything is switched off;
《━》 activates all parts;
《 》engages the starter
On being released at the «START» position, the key will
automatically return to «ON».