Publicité
Les langues disponibles
Les langues disponibles
• For product installation, please consider the following
instructions:
1. Avoid installing the device near sources of heat, such as
radiators, stoves, cookers, etc. or exposed to direct sunlight.
2. During automatic defrosting, check that the water that
forms on the rear wall of the compartment is draining
through the drainage system.
3. After having placed the device in the desired position, let
it stand for at least one hour before connecting it to the
power supply.
4. Check that the appliance is working properly before put-
ting food in it.
CAUTION: DO NOT INSTALL THE APPLIANCE NEAR HEAT
SOURCES AND LEAVE A SPACE OF AT LEAST 5 CM ABOVE THE
APPLIANCE.
• Installation in the column
The dimensions of the housing in the column must corre-
spond to those shown in the figure.
3 Place the unit in the slot against the side panel adjacent to
the opening.
3a Adjust the foot until the upper panel is in contact with the
cabinet and fix the upper part of the appliance using the
screws provided, in the panel previously drilled above the
strip.
3b Anchor the bottom of the appliance to the wall of the cabi-
net using the special parts provided.
3c Fix the two lower legs in the holes in the base of the cabi-
net.
3d If supplied as standard, apply the plastic seal.
3e Anchor part X to the appliance door using the screws.
3f Fit and fix the sliding Y part with screws, after adjusting the
housing door.
- 12 -
Publicité
