Adjust the position of the refrigerator leaving a space of 6
mm between the inside wall of the cabinet and the outside
walls of the refrigerator. Secure the watches to the horizontal
frame using the screws.
4. Place the gasket in the opening (about 10mm) between
the lower front frame and the bottom of the cabinet. Secure
the lower brackets (3) to the lower front frame with the
screws (2). Secure the lower brackets to the bottom of the
cabinet using the screws (2).
5. Position the gaskets correctly in the refrigerator open-
ings on the left, top and right.
6. Secure the door to the brackets (4) (one for each position
at the top and bottom) with the screws (2). Close the refriger-
ator and cabinet doors, then open them fully and mount the
connection plate (5) on the corresponding support, fixing it to
the cabinet door. The space "✝" between the connection plate
and the edge of the cabinet is equal to the thickness of the
outside panel of the cabinet, approximately 20mm. Adjust
the connection element so that the handle side of the cabinet
door does not come into contact with the body of the appli-
ance when it is closed (space of approx. 1 mm for large appli-
ances). Fit the second eventual door connection element.
7. Close the hole in the appliance door with the plug.
Figure 2
- 9 -