Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
INSTALLER CHECKLIST
Your installer must have completed and checked the
following:
The dishwasher is square and level.
The dishwasher is fastened securely to the
cabinetry.
The dishwasher door opens and closes freely. The
dishwasher door must close without hitting any
cabinetry or countertop.
The inlet water supply is turned on and checked
for leaks.
The drain hose has been connected and checked
for leaks. There must be no kinks or obstructions
in the drain hose.
The drain hose must be installed with a 30" (762
mm) high drain loop for drain hook-ups without any
air removed.
If you connect the water drain hose to a trap spigot
under the sink, remove the plastic membrane. If
you do not remove the entire membrane, leftover
food could cause a blockage in the drain hose
spigot. Ensure a hose clamp is used to secure the
hose to the spigot.
The spray arms are free and rotate freely.
The rinse cycle has been run.
The water level will be below the filter screen after
the end of the wash program. It is normal to find
some water in the drain filter area.
24
FINAL INSTRUCTIONS
1) Press the On/Off button to turn the dishwasher on.
2) Power indicator light comes on.
3) Use the Program Select button to choose a washing
program.
4) Start the program with the Start/Pause/Cancel button.
5) Run the dishwasher through one complete cycle. When
the wash cycle is completed, use the On/Off button to
turn the dishwasher off.
NOTE
If the dishwasher does not operate
properly, see the Self Help Tips.
Fig. 30
Publicité
