Bosch NIT5668UC Mode D'emploi page 14

SpeedBoost function
®
The SpeedBoost function can be used to heat large
®
amounts of water faster than by using heat level
Limitation on use
This function is available on all elements, provided that
no other element in the same group is operating, (see
picture). If this is not the case, the
flash on the selected element display; then it will
automatically set the power level
Activation
Select an element.
1.
Touch the Speed Boost key.
2.
lights up on the display.
›
The function is activated.
Deactivation
Select the element on which SpeedBoost
1.
Touch the Speed Boost key.
2.
goes out on the display and the element switched
›
back to heat setting
Š
The function is deactivated.
Note: In certain circumstances, the function may be
deactivated automatically to protect the internal
electronic components of the cooktop.
Basic settings
The appliance has various basic settings. You can adjust
these settings to the way you usually cook.
Display Function
Automatic child lock/panel lock
™‚
Off*
‹
On
‚
™ƒ Audible signals
‹ Confirmation signal and error signals deactivated
Only error signals activated
‚
Only confirmation signals activated
ƒ
All signals activated*
„
Automatic timer
™†
Off*
‹
‚ - ŠŠ
14
and symbols will
› Š
.
Š
is set.
®
.
Automatic shut-off time
Panel lock
You can use the child safety panel lock to prevent
. children from accidentally turning the cooktop on.
Š
Turning the panel lock on
The cooktop must be turned off.
Touch Panel Lock for 4 seconds. The
Panel Lock lights up for 10 seconds. The cooktop is now
locked.
Turning the panel lock off
Touch Panel Lock for 4 seconds. The child lock is now
deactivated.
CAUTION
9
The child lock may be accidentally turned on and off
due to:
water spilled during cleaning
▯
food that has overflowed
▯
objects being placed on the Panel Lock key.
▯
Automatic panel lock
With this function, the panel lock is automatically
activated whenever you turn off the cooktop.
Switching on and off: You can find out how to switch the
automatic panel lock on in the section ~ "Basic
settings"
Automatic time limitation
If the element is used for prolonged periods of time
without changes in the settings being made, the
automatic time limitation function is triggered.
The element stops heating.
indicator /
•
The indicator goes out when any symbol is pressed. The
element can now be reset.
When the automatic time limitation is activated depends
on the selected heat level (from 1 to 10 hours).
and the residual heat
"‰
flash alternately in the display.
œ
indicator over
Ú