Argo Oscar twin basic Mode D'emploi page 8

*
.
567
2. Electronic thermostat cursor
6. High fan speed push-button
*
7. Low fan speed push-button *
densate evacuation system.
BEFORE USING ™E APPLIANCE
• Check that the power supply at the location where the air conditioner is going to be used is 220/240 volt, single phase, 50 cycles.
I other electic appliances.
recommended.
• The unit has to be connected according to the local electrical rules.
• Make sure that circuit breakers, fuses, etc, are of sufficient capacity to handle a start-up current of 21 A.
• Do not install the air conditioner where it could be wetted by drops of water (i.e. in laundries).
• Before connecting the air conditioner to a power socket, make sure that the socket is provided with an earth connection in
• Never use the power plug as a mean to start or stop the air conditioner: always use the push-button switch on the air conditioner
control panel.
• The manufacturer assumes no responsabilities if the safety regulations or local codes are not observed.
• WARNING!
Wait for 3 minutes after each previous stop of compressor before re-starting the appliance. Several stops and re-starting
in a short time could damage the compressor. Avoid quick movements of the termostat cursor in both directions when
The air conditioner is made of two units interconnected by a flexible tube. The indoor unit, movable on wheels, must be placed
in the room to be air conditioned, near a window, a balcony-door or a perimeter wall. The outdoor unit, that provides to the
disposal of heat and condensation, must be located outside, on a window sill, or balcony.
/--»-Ii .... l
/Il.-.----3,4 --
..1.1 1 ....
8
-
7