Makita DSL800 Manuel D'instruction page 9

3. Insert the inner tray into the tool bag, and then fix
the inner tray with hook and loop fastener as shown in
the figure.
1
2
► 1. Hook and loop fastener 2. Inner tray
Installing the abrasive disc
2
1
► 1. Abrasive disc 2. Pad
Remove any dirt or foreign matter from the pad, and
then attach the abrasive disc to the pad while aligning
the holes in the abrasive disc with those in the pad.
Adjusting the pipe length
CAUTION:
When adjusting the pipe length,
hold the tool horizontally. Otherwise, the pipe
length may change unintentionally and it may cause
an injury or malfunction of the tool.
NOTICE:
Do not extend the pipe beyond the
limit. Failure to do so may cause a malfunction of
the tool.
1
2
► 1. Sleeve 2. Pipe
To adjust the pipe length, loosen the sleeve, then adjust
the length of the pipe, and then tighten the sleeve.
Installing or removing the dust
collection brush
Before sanding operation, install the dust collection
brush to the sanding head as shown in the figure.
1
► 1. Dust collection brush 2. Sanding head
9 ENGLISH
2