Miller RAD-780 Mode D'emploi page 20

2-11. Reversing Motor Direction When Configuring Torch To Left Of Center
2
Holding handle, insert sleeve into plug hole, allowing push rod
button to back out of handle.
Turn handle to free contact.
Press in push rod button to remove lead.
SECTION 3 – MAINTENANCE AND TROUBLESHOOTING
3-1. Routine Maintenance
Replace
Cracked
Parts
OR
OM-1598 Page 16
1
3 4
4
Y Disconnect power before maintaining.
Replace
Unreadable
Labels
Cord
Blow Out Or
Vacuum Inside.
During Heavy
Service,
Clean Monthly
5
3 Months
Repair Or
Replace
Cracked
Weld
Cable
Gas
Hose
6 Months
1 Power Cord Connector
2 Screws
Loosen screws
3 Strain Relief Housing
Remove strain relief housing.
4 Pins
5 Pin Extraction Tool
Use tool to remove and switch loca-
tions of pins 1 and 3.
Reassemble connector.
Tools Needed:
Part No. 048471
Ref. 120 350-A / Ref. 152 068
Clean
And
Tighten
Weld
Terminals
Gun
Cable
Clean
Drive
Rolls