Publicité
Les langues disponibles
Les langues disponibles
1.) To avoid scratches and dents when re-routing hoses and cables remove the gas tank first.
Remove fairing bracket and mirrors if necessary. Always disconnect battery ground before
working on electric wiring and switches!
2.) Remove handlebar controls, clutch lever bracket and brake cylinder assy, then remove the
original handlebar.
3.) Mount the adaptor on standard top yoke (or swap new yoke depending on kit type). To demount
the ignition lock you mostly have to drill out the heads of the breakaway screws. After mounting
the ignition lock with the attached bushings and new screws at the LSL-yoke you have to drill out
the heads of the screws as theft protection, if your bike is not equipped with an immobilizer. If the
crown nut had to be removed tighten up to original torque. Mount the new handlebar without
tightening the screws of the clamps too strong. Re-route cables and hoses if necessary. Please
refer to "specific mounting instructions" for re-routing.
4.) Remove brake-hose(s). Caution: avoid brake fluid on painted surfaces! Mount enclosed
brake-hose(s) with new gaskets.
Caution: Any work on the brake system or bleeding the system should be done by an
authorized dealer or a qualified mechanic! Pump brake lever until proper pressure is felt
on lever. Test brakes at slow speed!
5.) Now mount the handlebar controls and clutch/brake assy. Set drillings to fix controls on the
handlebar. If other than LSL handlebars are chosen, use tapes or metal sheets under the controls
to fix them on the handlebar. Now tighten handlebar clamps equally up to 25Nm / 18.4lbf ft torque.
Make sure that no cable is bended and stays tension-free when turning the handlebar.
6.) Shorten fairing and screen, if necessary, to allow full steering movement of handlebar with
sufficient space at levers and switches. Please refer to "specific mounting instructions" for
shortening. Check throttle, choke and clutch cables function and clearance on left and right
steering angle. Adjust or re-route if necessary. After finishing check all connections.
7.) Always check local laws and your manufacturer's warranty conditions for using aftermarket parts
on your bike!
Ride safe and have fun!
———————————————————
Rev.00 02/03/2015
LSL–Superbike-Kit Fitting Instructions
Zubehör von
Das Original
—
——
Seite 2 von 2
Publicité
