Lotus BM-74G Instructions Pour L'installation Et L'emploi page 31

GB IE
IT CH
Lighting the pilot burner
Check that the thermostat knob is in position .
Keeping the knob pushed down, press the piezo button repeatedly. The flame lights automatically and can be seen
through the inspection hole in the front panel. After lighting, hold the knob down for another 20-30 seconds, to allow
the thermocouple to warm up, then release it. The flame may go out, in which case it is necessary to repeat the
procedure.
Lighting the main burner and regulating the temperature
After releasing the knob, the gas goes into the safety valve.
Turning the graduated knob from 30 a to 90° C, the gas flows to the main burner which then lights.
Putting out the main burner
Turn the knob into position ; only the flame of the pilot burner remains lit.
Turning off the appliance
Push and turn the knob into position "0". This command blocks the gas supply to both the main burner and the pilot
burner.
Emptying the water container
Turn the drainage tap from the "off" position to "on".
NB: pay attention to the distance between the appliance and the corners of the support.
NB: it is recommended to carry out this operation using water which is not too hot.
31