Lotus BM-74G Instructions Pour L'installation Et L'emploi page 30

With prolonged use of the appliance, it is essential to carry out regular maintenance for the safe functioning of the
appliance; we therefore recommend drawing up a contract for after sales service.
Maintenance must be done only by specialized personnel, observing the norms in force and our indications.
It is possible to substitute parts such as the valve, the piezoelectric lighter or gas pipes very simply. To substitute the
parts, proceed as follows:
• Valve: after removing the front panel, unscrew the screwed fittings of the gas connections, remove the fitting and
take out the thermostat bulb, then substitute the faulty parts, installing the new ones in order.
• To substitute the thermocouple, unscrew the pilot burner fitting, likewise the valve fitting and substitute the
element.
• The spark plug must be unscrewed and substituted.
Attention!
Before lighting the appliance, it must be washed with water and dish-washing detergent, rinsed thoroughly and filled
with water up to the level indicated by the mark on the back of the water container.
DO NOT START UP THE APPLIANCE WITH THE WATER CONTAINER EMPTY.
It is advisable to connect the appliance to the hot water pipe to reduce heating time; it is also recommended to install a
cut-off cock upstream from the appliance.
The drain piping must be connected to a suitable drain and conform with the norms.
The piping must be connected in such a way as to avoid contractions or siphons. The drainage of water is free, therefore
it is essential that the drain is lower than the outlet of the piping.
The appliance must be connected to an equipotential
back of the appliance and is identified by the symbol.
Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
Before using the appliance, it is necessary to clean it carefully, especially the water container (see paragraph "cleaning
and care").
Check the connection of the appliance and start it up following the instructions, "Instructions for use".
Attention! Use the appliance only under surveillance.
Check that the drainage tap is in the "off" position.
Fill the water container with water (max.60°C) up to the level indicated by the mark, by pressing the button.
GB
IT
MAINTENANCE
Spare parts
WATER CONNECTION AND DRAINAGE
EQUIPOTENTIAL
Starting up
Water filling
IE
CH
system. The connection screw is positioned at the
30