EUROM 161335 Manuel D'utilisation page 17

Filter cleaning system
When you feel that the suction is
getting weaker, please remove the
tube and jam the hose by hand (while
the equipment is working). Then press
the filter cleaning button 10-15 times:
this will clean the filter and recover the
suction force.
Emptying barrel
Open both the locking blocks (4) en take the
up housing from the vacuum cleaner. Remove
the dust out of the barrel and clean the barrel
if necessary. At the end, place back the up
housing and close the locking blocks.
Cleaning the filter
Clean the filter regularly. Open both clips and remove
the lid of the vacuum cleaner. Turn the lid from the
filter, slide the HEPA filter off the frame and carefully
wash with lukewarm water. Do not use any aggressive
or abrasive cleaning agents!
Let the filter dry thoroughly before replacing. Never
use the device without a filter!
Maintenance
 Keep the body of the device, the filter and accessories clean and regularly check
to ensure no excess air is being sucked in.
 Check the cable and plug regularly for damage. Do not use the device if it has a
damaged cable and/or plug but take it to an authorised engineer to be replaced!
 Regularly check to ensure no objects are stuck in the suction mouth, hose or
pipe. Remove them if necessary.
 Use the device carefully; ensure it does not fall, bump into other objects or
become otherwise damaged.
 Store the device in a dry environment.
 Never use the device for too long in one go; give it regular opportunities to cool
down. This will extend its life expectancy.
 If the device falters, vibrates, makes peculiar noises or emits a burning smell,
stop using it immediately and ask your supplier or service provider to
check/repair it.
17