Publicité
Les langues disponibles
Les langues disponibles
Socket
In order to use the socket, you must lift the lid and insert the plug into the socket.
Then use the ON/OFF switch to select the appropriate setting:
I = device works, power from socket
O = device off, power to socket (max. 2000W)
II = power to socket, connected device will work. After 5-8 seconds the vacuum
clean will start. If the connected device is switched off, the vacuum cleaner
will also stop after 5-8 seconds.
Extra paper filter
An extra paper
filter (dust bag)
is supplied with
the device. You
are advised to
replace the HEPA
filter with this
filter if you
intend to clean
very fine
particles, e.g. in the event of drilling or sanding work. This will prevent you from
having to clean the HEPA filter during this type of work.
Install the paper dust bag as follows:
Remove the HEPA filter (see: Cleaning the filter)
Remove the 'knee' on the air inlet within the drum
Slide the opening in the paper dust bag over the air intake opening
Secure the cover (without HEPA filter, secure with clamps)
Cleaning up
Switch the device off and remove the plug from the
socket. Wind the electrical cable around the cable
hanger; the upper section provides a groove into
which you can wedge the plug. Place the accessories
at the appropriate locations behind the device, see
image.
Cleaning and maintenance
Before cleaning or maintenance: always switch off the equipment and unplug it.
16
Publicité
