Publicité
Les langues disponibles
Les langues disponibles
Operation
Put the hose connection in the
machine; if necessary, turn it a bit
till the narrow part is in total in the
machine. Then turn it as far as
possible clockwise.
After this, connect the accessories
you wish with a twisting force, see
picture.
You can adjust the telescope tube
by pushing the sliding block 2A
down and and tracking/pushing the
lowest tube to the length you wish.
Insert the plug into the earthed
socket.
Press the switch on/off to I to turn on.
If necessary, due to the surface and task, the hair or rubber strips can be
removed from the suction mouth. In order to do so, slide the discs on the
suction mouth outwards, take the strip holder from the suction mouth, slide the
excess strip out and replace the holder.
For the vacuuming of liquid the motor (which is
situated in the cap) is provided with a floater that is
hanging under the motor, in the barrel. For the
vacuuming of dry dirt and dust the motor is provided
with a filter that the floater surrounds and in that way
prevents that dust enters the mechanic system. Do you
want to vacuum liquid, remove than the filter by
opening the locking blocks, to lift and turn the cap, to
turn the lid from the filter (see image), and to slide the
filter from the floaters frame. Now you can remove the
filter. Bring the cap back in its position and close the
blocks.
Be carefull!
Never vacuum dust without the HEPA filter around the floater!
Never vacuum liquid without the water filter around the floater!
Tank drain
The Force 1430S has the possibility to drain the sucked-up water by the tank drain
at the barrel. For this purpose, place the device at a sink or something like that and
loosen the tank drain: the water is now running away. Finally tighten the cap firmly
again.
15
Publicité
