Publicité
Les langues disponibles
Les langues disponibles
BEFORE USING YOUR APPLIANCE
Preparing Your Dishwasher for the First Use
Make sure the electricity and supply water specifications match the values indicated in the
•
installation instructions for the machine.
Open the door of the dishwasher.
•
Remove all packaging material inside the machine.
•
Set the water softener level. (See: SETTING THE WATER, select models).
•
Set the rinse aid dosage (See: FILLING THE RINSE-AID AND SETTING).
•
Fill the salt container (See: FILLING THE DISHWASHER SALT DISPENSER, select models).
•
Fill the rinse aid compartment. (See: FILLING THE RINSE AID AND SETTING).
•
Place the dishes in accordance with the instructions in the user manual.
•
Put an adequate amount of detergent into the detergent dispenser. (See: FILLING THE
•
DETERGENT).
Make sure that the upper and lower impellers rotate freely.
•
Select the program according to the amount of dirt (See: PROGRAM TABLE).
•
Close the door of the dishwasher. (Push the baskets in. Then lift the door upwards and push
•
until it clicks into position).
CAUTION: To prevent injuries, ensure that your hand is not jammed or crushed between the
door and the appliance.
WARNING: While the appliance is running, if you open the door, all functions are automatically
interrupted.
CAUTION: There is a chance of hot steam will come out from the unit when you open the door of
your machine. Be aware of potential injuries.
Setting the Water Softener (SELECT MODELS)
The dishwasher needs soft water for good cleaning results. Hard water results in a build-up of
•
calcium deposits on dishware and in the dishwasher. Your dishwasher has a special water
softening system to remove the hardness of the tap water. Setting this system correctly will
increase the washing effectiveness.
Water supplies with a hardness level higher than 9 °f (French Water Hardness) need to be
•
softened.
If the hardness level of the water that you use is above 9 °f (French standard for water hardness)
•
or if you are using well water, then it is recommended to use a filter and water purification
devices.
The dishwasher is pre-programmed at the factory setting level 1 (inactive) of water hardness. If
•
this setting corresponds to the hardness of your water, you do not need to do anything more.
The dishwasher must be programmed for the water hardness in your area.
•
To find out the hardness level of water in your area, contact your local Water Board or Determine
•
the water hardness level with the help of the test strip provided.
WARNING: If you move to a different location, the level of water hardness will possibly be
different. It is essential to set again the water hardness in order to obtain optimum washing
efficiency.
9
Publicité
