Publicité
Les langues disponibles
Les langues disponibles
ISSUE
The program does not
start.
Water remains inside
the machine.
The machine stops
while washing.
Shaking and banging
noises are heard while
washing.
Food particles stay on
the dish after the
washing cycle is
complete.
TROUBLESHOOTING
POSSIBLE CAUSE
Your Dishwasher is not plugged
in.
Your Dishwasher is not turned on. Turn your Dishwasher on by pressing
The fuse has blown out.
The water inlet tap is closed.
Your Dishwasher door is open.
The water inlet hose and machine
filters are clogged.
The water drain hose is clogged
or twisted.
The filters are clogged.
The program is not finished yet.
Power failure.
Water inlet failure.
The spray arm is hitting the
dishes in the lower basket.
Dishes placed incorrectly,
sprayed water not reaching
affected dishes.
Dishes are leaning against each
other.
Not enough detergent was used.
The wrong wash program was
selected.
Spray arms clogged with food
waste.
Filters or water drain pump
clogged or filter misplaced.
TROUBLESHOOTING
Plug your Dishwasher in.
the On/Off button.
Check your indoor fuses.
Turn on the water inlet tap.
Close the Dishwasher door.
Check the water inlet hose and
machine filters and make sure they are
not clogged.
Check the drain hose, then either
clean or untwist it.
Clean the filters.
Wait until the program is finished.
Check the main power source.
Check the water tap.
Rearrange or remove items blocking the
spray arm.
Do not overload baskets.
Place dishes as instructed in the
section onloading your dishwasher.
Use the correct amount of detergent, as
instructed in the program table.
Use the information in the program table
to select the most appropriate program.
Clean the holes in the spray arms with
thin objects.
Check that the drain hose and filters are
correctly fitted.
29
Publicité
