Summit DW186NTADA Mode D'emploi page 30

FAULT
Stains remain on
dishes.
Dishes do not dry.
Rust stains forming
on dishes.
Detergent remains in
the detergent
compartment.
If your appliance shows other symptoms than those described above, or if you have checked all
items listed as the cause and the problem still exists, then call Summit Appliance Customer Service
1-800-932-4267
at
POSSIBLE CAUSE
Not enough detergent was used.
Rinse aid dosage and/or water
softener setting set too low.
High water hardness level.
The salt compartment cap is not
closed properly.
The drying option was not
selected.
Rinse aid dosage set too low.
The stainless-steel quality of the
dishes is insufficient.
High level of salt in the water.
The salt compartment cap is not
closed properly.
Too much salt was spilled in the
Dishwasher while filling it with salt.
Poor electrical grounding system. Consult a qualified electrician
Detergent was added when the
detergent compartment was wet.
or visit www.summitappliance.com/support.
TROUBLESHOOTING
Use the correct amount of detergent, as
instructed in the program table.
Increase rinse aid and/or water softener
level.
Increase the water softener level and add
salt.
Check that the salt compartment cap is
closed properly.
Select a program with a drying option.
Increase rinse aid dosage setting.
Only use dishwasher-safe sets.
Adjust the water hardness level using a
water hardness table.
Check that the salt compartment cap is
closed properly.
Use a funnel while pouring salt into the
compartment to avoid spillage.
immediately.
Make sure the detergent compartment is
dry before use.
30