Summit DW186NTADA Mode D'emploi page 31

AUTOMATIC FAULT WARNINGS
TROUBLE
CODE
FF Water inlet system failure
F5 Pressure system failure
Continuous water input
F3
Inability to discharge water
F2
F8
F1
Faulty electronic card
FE
F7
F9
F6
HI
Practical Information
When the machine is not in operation:
•
1. Disconnect the unit and close the tap.
2. Leave the door slightly open to prevent odor formation.
Select the dry option to remove water droplets.
•
Place dishes in the machine properly to achieve efficient energy consumption, washing, and
•
drying performance. Please see the program and consumption table for more information.
Rinse dirty dishes before placing them in the dishwasher.
•
Only use the Rinse program when necessary.
•
Do not place the machine near a refrigerator because it will reach high temperatures.
•
If the machine is in an area that is at risk of freezing, close the tap, disconnect the inlet hose
•
from the tap and drain the water inside the hose and the machine completely.
POSSIBLE ISSUE
Heater error
Overflow
Overheating
Divisor position error
Faulty heater sensor
High voltage failure
WHAT TO DO
Make sure the water inlet tap is open and water is
Separate the inlet hose from the tap and clean the
filter of the hose.
Contact for service if the error continues.
Contact for service.
Close the tap and contact for service.
The water discharge hoses and filters may be
clogged.
Cancel the program.
If the error continues, contact for service.
Contact for service.
Unplug the machine and close the tap.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
31
flowing.