Publicité
Les langues disponibles
Les langues disponibles
To cancel the Delay Timer function:
1. Open the door of the dishwasher
2. Press and hold program
Selection + Cancel key for 3 seconds
3. When the program Selection + Cancel key is pressed and held, "1" appears on the display. At the
end of the cancellation process, "--" appears on the display and delaying process is cancelled.
i. You can select and start a new program following the cancellation of Delay Timer function.
ii. Delay Timer function can not be set after the program starts.
Starting the Program
Open the door of your machine. Select the program and auxiliary functions. The program duration
and program number will appear on the display alternately. Press "Start/Pause + On/Off" key. Close
the door within 4 seconds, the program will start. If 4 seconds is exceeded and the door is closed,
program will not start.
Your machine performs water softening depends on model hardness level of
the supply water (SELECT MODELS). Remaining time displayed towards the end in some programs
can be different from the time indicated at the beginning due to this process. The total time can also
change while the program is running depending on the ambient temperature where your machine is
installed, temperature of the supply water and amount of the dishes.
If the door is opened while the machine is running, the machine will switch to the standby mode.
Press the Start/Pause key and close the machine door within 4 seconds, then the program will
resume.
Child (Key Lock)
Not available.
Canceling the Program
1. Press the Program Selection + Cancel key for 3 seconds to cancel the program.
2. After 3 seconds, "1" will appear on
the display. For a couple of minutes, the machine will fulfill the necessary operations required to
cancel the program.
3. There might be residues of detergent or rinse aid left in the machine and/or on the pieces being
washed depending on the step the program you have canceled was in.
Rinse-Aid Indicator
Please check the rinse aid indicator on the control panel to see whether there is adequate amount
of rinse aid in the dishwasher or not. You need to refill the rinse aid reservoir with rinse aid
whenever rinse-aid warning indicator appears on the control panel of your machine.
End of Program
End of program indicator will light up continuously when the washing program is over.
1. Open the door of the machine.
2. Press Start/Pause + On/Off key to turn off your machine.
3. Close the tap.
4. Unplug the machine from the socket.
Leave your dishes in the machine for about 15 minutes to cool down after they are washed. Your
dishes will dry in a shorter time if you leave the door of your machine ajar during this period. This
process will increase the drying effectiveness of your machine.
25
Publicité
