Tunturi FitCycle 20 Manuel De L'utilisateur page 17

Explanation of buttons
MODE
- Press MODE button to select console functions;
Time, Speed, Dist, ODO, Cal. & Pulse
- Push and hold for 4 seconds to reset: Time,
Count, Dist & Calorie.
‼ NOTE
• Total Count can only be reset by a batteries
exchange.
Extra notes
- If the display is faint or shows no figures, please
replace the batteries.
- The monitor will automatically shut off if there is
no signal received after 4 minutes .
- The monitor will be auto-powered on when
starting to exercise push button w/signal in.
- The monitor will automatically start calculating
when you start to exercise and will stop
calculating when you stop exercising for 4
seconds .
Cleaning and maintenance
The equipment does not require special
maintenance. The equipment does not require
recalibration when it is assembled, used and
serviced according to the instructions.
⚠ WARNING
• Do not use solvents to clean the equipment.
• Clean the equipment with a soft, absorbent
cloth after each use.
• Regularly check that all screws and nuts
are tight.
• If necessary, lubricate the joints.
Replacing the batteries (Fig E )
The console is equipped with 2 AAA batteries at
the rear of the console.
- Remove the cover.
- Remove the old batteries.
- Insert the new batteries. Make sure that
batteries match the (+) and (-) polarity markings.
- Mount the cover.
Defects and malfunctions
Despite continuous quality control, defects and
malfunctions caused by individual parts can
occur in the equipment. In most cases, it will be
sufficient to replace the defective part.
- If the equipment does not function properly,
immediately contact the dealer.
- Provide the model number and the serial
number of the equipment to the dealer. State
the nature of the problem, conditions of use
and purchase date.
Trouble shooting:
- When the display of LCD is dim, it means the
batteries need to be changed.
- If there is no signal when you pedal, please
check if the cable is well connected.
‼ NOTE
• When stop training for 4 minutes, the main
screen will be off.
• If the computer displays abnormally, please
re-install the batteries and try again.
Transport and storage
⚠ WARNING
• Carry and move the equipment with at least
two persons.
• Move the equipment and carefully put the
equipment down. Place the equipment on
a protective base to prevent damage to the
floor surface.
• Move the equipment carefully over uneven
surfaces. Do not move the equipment
upstairs using the wheels, but carry the
equipment by the handlebars.
• Store the equipment in a dry place with as
little temperature variation as possible.
Additional information
Packaging disposal
Government guidelines ask that we reduce the
amount of waste material disposed of in land fill
sites. We therefore ask that you dispose of all
packaging waste responsibly at public recycling
centres.
English
17