Table Des Matières; Important Instructions; Document Information; Key To Symbols - Stiebel Eltron CNS 100-1 E Mode D'emploi Et Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONTENTS | OPERATION

IMPORTANT INSTRUCTIONS

OPERATION
1.
Important Instructions _________________________________________2
1.1 Document information ____________________________________________ 2
1.2 Key to symbols ______________________________________________________ 2
2.
Safety ____________________________________________________________3
2.1 Intended use _________________________________________________________ 3
2.2 Safety information _________________________________________________ 3
2.3 ETL / UL designation _______________________________________________ 3
2.4 Type label ____________________________________________________________ 3
3.
Register your product __________________________________________4
4.
Appliance description __________________________________________4
5.
CNS E Operation ________________________________________________4
5.1 Description of the user interface ________________________________ 4
5.2 Frost protection _____________________________________________________ 4
5.3 Limiting the temperature controller ____________________________ 4
5.4 Shutting down ______________________________________________________ 5
6.
Cleaning, care and maintenance ______________________________5
7.
What to do if ... _________________________________________________5
8.
Safety ____________________________________________________________5
8.1 General safety instructions _______________________________________ 5
9.
Appliance description __________________________________________5
9.1 Standard delivery ___________________________________________________ 5
10. Installation ______________________________________________________5
10.1 Installing the wall mounting bracket ___________________________ 5
10.2 Appliance installation _____________________________________________ 6
10.3 Dismounting the appliance _______________________________________ 6
10.4 Power supply ________________________________________________________ 6
10.5 Terminal block ______________________________________________________ 6
11. Appliance handover ____________________________________________7
12. Specifi cations ___________________________________________________7
12.1 Dimensions __________________________________________________________ 7
12.2 Minimum clearances to hard surfaces _________________________ 7
12.3 Specifi cations ________________________________________________________ 8
12.4 Wiring Diagram _____________________________________________________ 8
13. Warranty _________________________________________________________9
2
|CNS E
OPERATION
1.
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
When using electrical appliances, basic precautions should always
be followed to reduce the risk of fi re, electric shock, and injury to
persons, including the following:
1. Read all instructions before installing or using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. Keep combustible materials, such as
furniture, pillows, bedding, papers, clothes, etc. and curtains at
least 3 feet (1 m) from the front of the heater and keep them at
least 3 feet (1 m) away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or
near children or invalids and whenever the heater is left operating
and unattended.
4. Do not operate any heater after it malfunctions. Disconnect
power at service panel and have heater inspected by a reputable
electrician before reusing.
1.1

Document information

The chapter Operation is intended for users and heating
contractors.
The chapter Installation is intended for heating contractors.
Read these instructions carefully before using the
appliance and retain them for future reference. Pass
on the instructions to any new users.
1.2

Key to symbols

1.2.1 Layout of safety information
Safety information comprises a warning symbol, a keyword and
a text giving information. Safety information is printed on a grey
background.
Example:
1
2
DANGER: Electrocution
Install the appliance in such a way that control
equipment...
1 Symbol (see chapter on warning symbols/symbols)
2 Keyword (see chapter on keywords)
3 Description (see chapter on warning symbols/symbols)
4 Information text
3
4
WWW.STIEBEL-ELTRON-USA.COM

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cns 100-2 eCns 150-1 eCns 150-2 eCns 200-2 eCns 240-2 e

Table des Matières