Publicité
Les langues disponibles
Les langues disponibles
The doors are difficult to open
Explosion Hazard
Use nonflammable
cleaner.
Failure to do so can result in death, explosion, or fire.
•
Are the gaskets dirty or sticky? Clean gaskets with mild
soap and warm water.
The lights do not work
•
Is a light bulb loose in the socket or burned out? See
"Changing the Light Bulbs."
•
Is the dispenser
light set to OFF? On some models, the
dispenser light will operate only when a dispenser lever/pad
is pressed. If you want the dispenser light to stay on
continuously, set the dispenser light to ON, or (on some
models) NIGHT LIGHT or AUTO or HALF or DIM. See "Water
and Ice Dispensers."
•
Is the dispenser light set to NIGHT LIGHT or AUTO? On
some models, if the dispenser is set to the NIGHT LIGHT or
AUTO mode, be sure the dispenser light sensor is not
blocked. See "Water and Ice Dispensers."
Temperature
is too warm
•
New installation? Allow 24 hours following installation for
the refrigerator to cool completely.
•
Door(s) opened often or left open? Allows warm air to enter
refrigerator. Minimize door openings and keep doors fully
closed.
•
Large load of food added? Allow several hours for
refrigerator to return to normal temperature.
•
Controls
set correctly
for the surrounding
conditions?
Adjust the controls a setting colder. Check temperature
in
24 hours. See "Using the Controls."
There is interior moisture buildup
NOTE: Some moisture buildup is normal.
•
Humid room? Contributes
to moisture buildup.
•
Door(s) opened often or left open? Allows humid air to
enter refrigerator. Minimize door openings and keep doors
fully closed.
The ice maker is not producing
ice or not enough
ice
•
Refrigerator connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator to water
supply and turn water shutoff valve fully open.
•
Kink in the water source line? A kink in the line can reduce
water flow. Straighten the water source line.
•
Ice maker turned on? Make sure wire shutoff arm or switch
(depending on model) is in the ON position.
•
New installation?
Wait 24 hours after ice maker installation
for ice production to begin. Wait 72 hours for full ice
production.
•
Large amount of ice recently removed? Allow 24 hours for
ice maker to produce more ice.
•
Ice cube jammed
in the ice maker ejector
arm?
Remove ice from the ejector arm with a plastic utensil.
•
Reverse osmosis
water filtration
system connected
to
your cold water supply? This can decrease water pressure.
See "Water Supply Requirements."
The ice cubes
are hollow or small
NOTE: This is an indication of low water pressure.
•
Water shutoff
valve not fully open? Turn the water shutoff
valve fully open.
•
Kink in the water source line? A kink in the line can reduce
water flow. Straighten the water source line.
•
Reverse osmosis
water filtration
system connected
to
your cold water supply? This can decrease water pressure.
See "Water Supply Requirements."
•
Questions
remain regarding
water
pressure?
Call a
licensed, qualified plumber.
Off-taste,
odor or gray color in the ice
New plumbing
connections?
New plumbing connections
can cause discolored or off-flavored
ice.
Ice stored too long? Discard ice. Wash ice bin. Allow
24 hours for ice maker to make new ice.
Odor transfer
from food? Use airtight, moisture-proof
packaging to store food.
Are there minerals
(such as sulfur) in the water? A water
filter may need to be installed to remove the minerals.
Is there a water filter installed
on the refrigerator?
Gray or
dark discoloration
in ice indicates that the water filtration
system needs additional flushing.
10
Publicité
