Publicité
Les langues disponibles
Les langues disponibles
Should you have any problem(s) with your vacuum cleaner, review the table
below for solutions to minor performance issues.
WARNING
Disconnect electrical supply before performing maintenance to the vacuum
cleaner. Failure to do so could result in electrical shock or personal injury.
PROBLEM
The plug is not plugged into the
wall outlet.
The On/Off switch is not pressed
to start the vacuum cleaner.
Vacuum cleaner
will not run.
Defective wall outlet.
The vacuum body is overheated.
The motor is damaged.
The hose and accessories are
not installed correctly.
The hose is not installed in the
correct place when using the
upright mode.
Dust bag is not installed
Poor job of dirt
correctly.
pick-up.
Full or clogged dust bag.
There is a clog in the air path.
Suction control is in open
position.
TROUBLESHOOTING
POSSIBLE CAUSE
Be sure power cord plug is fully
plugged into outlet.
Press the On/Off switch to "I" or "II"
position.
Check with a good appliance or lamp.
Have outlet properly serviced.
Unplug the power cord and let the
vacuum cool down for 50 minutes.
Call 1-866-384-8432 for assistance.
Check the hose and accessories for
correct installation and ensure they are
Check and ensure the hose is installed
correctly into the main body (page 7).
Check dust bag for correct installation
place.
Change the dust bag.
Check and remove all clogs. Follow
instructions on page 23.
Adjust the suction control to increase
suction. Follow instructions on page
17.
-25-
SOLUTION
Publicité
