Argo DELUXE 9000 UI Manuel D'utilisation Et D'installation page 45

WARNING
Do not repair the air conditioner by yourself as wrong maintenance may cause electric shock or fire or explode, please
contact the authorized service center and let the professionals conduct the maintenance, and checking the following
items prior to contacting for maintenance can save your time and money.
Phenomenon
The air conditioner does not work
Il climatizzatore non si avvia dopo averlo
arrestato
The air conditioner stops running after it starts
up for a while
The wind blows out, but the cooling/heating
effect is not good
The indoor unit blows out odor
There is sound of running water during the
running of air conditioner
A slight "click" soundis heard at the of start-up
or shut-down
The indoor unit makes abnormal sound
There are water drops over the surface of the
indoor unit
During the cooling operation, the indoor unit
outlet sometimes will blow out mist.
V 11/23
TROUBLESHOOTING
Causes
• There might be power outages.
• Power plug may be loose out from the
socket.
• Power switch fuse may blow.
• The time for timing boot is yet to come.
• Il climatizzatore non riparte immediatamente
a causa del dispositivo di protezione
• May have reached the setting temperature.
• May be at a defrosting state.
• Shutdown Timer may be set.
• Excessive accumulation of dust on filter,
blocking at air inlet and outlet, and the
excessively small angle of the louver blades
all will affect the cooling and heating effect.
• Poor cooling and heating effect caused by
doors and windows opening, and unclosed
exhaust fan.
• Mode setting is incorrect,
temperature and wind speed settings are
not appropriate.
• The air conditioner itself does not have
undesirable odor. If there is odor, it may
be due to accumulation of the odor in the
environment.
• When the air conditioner is started up or
stopped, or the compressor is started up
or stopped during the running, sometimes
the "hissing" sound of running water can
be heard.
• Due to temperature changes, panel and
other parts will swell, causing the sound of
friction.
• The sound of fan or compressor relay
switched on or off. When the defrosting is
started or stop running, it will create sound.
• Too much dust accumulation on the air filter
of the indoor unit may result in fluctuation
of the sound.
• Too much air noise when "Strong wind" is
turned on.
• When ambient humidity is high, water
drops will be accumulated around the air
outlet or the panel, etc.
• Prolonged cooling run in open space
produces water drops.
• Too small opening angle of the louver
blades may also result in water drops at
the air inlet.
• When the indoor temperature and humidity
are high, it happens sometimes.
Troubleshooting
• Wait until power is restored.
• The plug in the plug tightly.
• Replace the fuse.
• Wait or cancel the timer settings.
• Attendere almeno 5 minuti e riprovare.
• It is a normal function phenomenon.
• It will automatically restore and run again
after defrosting.
• If you continue to use, please turn it on
again.
• Please clean the filter, remove the obstacles
at the air inlet and outlet and regulate the
angle of the louver blades.
• Please close the doors, windows, the
exhaust fan, etc.
• Please re-select the mode, and set the
appropriate temperature and wind speed.
and the
• Clean the air filter or activate the cleaning
function.
• This is the sound of the flow of the
refrigerant, not a malfunction.
• This is normal, not a fault.
• That is due to the refrigerant flows to reverse
direction. They are not malfunctions.
• Clean the air filters in time.
• This is normal, if feeling uncomfortable,
please deactivate
function.
• This is a normal physics phenomenon.
• Close the doors and windows.
• Increase the angle of the louver blades.
• This is because the indoor air is cooled
rapidly. After it runs for some time, the
indoor temperature and humidity will be
reduced and the mist will disappear.
the "strong wind"
45