Argo DELUXE 9000 UI Manuel D'utilisation Et D'installation page 44

WARNING
• Before the cleaning of the air conditioner, it must be shut down and the electricity must be cut off for more than 5
minutes, otherwise there might be the risk of electric shocks.
• Do not wet the air conditioner, which can cause an electric shock. Make sure not to rinse the air conditioner with
water under any circumstances.
• Volatile liquids such as thinner or gasoline will damage the air conditioner housing, therefore please clean the
housing of air conditioner only with soft dry cloth and damp cloth moistened with neutral detergent.
• In the course of the usage, pay attention to cleaning the filter regularly, to prevent the accumulation of dust
which may affect the air conditioner performance. If the service environment of the air conditioner is dusty,
correspondingly increase the number of times of cleaning. After removing the filter, do not touch the fin part of the
indoor unit with the finger, and no force to damage the refrigerant pipeline.
CLEAN THE PANEL
Clean the front panel of the indoor unit with a cloth and lukewarm water, below 40 °C. Do
not disassemble the panel for cleaning.
CLEAN THE AIR FILTER
Remove the air filters
The air filters are located at the top of the indoor unit. Remove them by gently pulling
them upwards.
Clean the air filter
Use a vacuum cleaner or water to rinse the filter, and if the filter is very dirty (for
example, with greasy dirt), clean it with warm water (below 45 °C) with mild
detergent, and then put the filter in the shade to dry in the air.
Mount the air filter
Reinstall the dried filter in reverse order of removal, then cover and lock the panel.
CHECK BEFORE USING
1. Check whether all the air inlets and outlets of the units are unblocked.
2. Check whether there is blocking in the water outlet of the drain pipe, and immediately clean it up if any.
3. Check the ground wire is reliably grounded.
4. Check whether the remote control batteries are installed, and whether the power is sufficient.
5. Check whether there is damage in the mounting bracket of the outdoor unit, and if any, please contact our local
service center.
MAINTENANCE AFTER USING
1. Cut off the power source of the air conditioner, turn off the main power switch and remove the batteries from the
remote controller.
2. Clean the filter and the unit body.
3. Remove the dust and debris from the outdoor unit.
4. Check whether there is damage in the mounting bracket of the outdoor unit, and if any, please contact our local
service center.
V 11/23
CLEAN AND CARE
44