Argo DELUXE 9000 UI Manuel D'utilisation Et D'installation page 36

INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH THE
EUROPEAN DIRECTIVE 2012/19/EU
At the end of its working life this equipment must not be disposed of as an household waste. It must be
taken to special local community waste collection centres or to a dealer providing this service. Disposing
of electrical and electronic equipment separately avoids possible negative effects on the environment
and human health deriving from an inappropriate disposal and enables its components to be recovered
and recycled to obtain significant savings in energy and resources. In order to underline the duty to
dispose of this equipment separately, the product is marked with a crossed-out dustbin
OPERATING RANGE
Cooling mode: from -15 °C to +53 °C (outdoor temperature)
Heating mode: from -30 °C to +32 °C (outdoor temperature)
Indoor temperature setting range: 16°C - 32°C
• When the temperature is too high, the air conditioner may activate the automatic protection device, so that the
air conditioner could be shut down.
• When the temperature is too low, the heat exchanger of the air conditioner may freeze, leading to water dripping
or other malfunction.
• In long-term cooling or dehumidification with a relative humidity of above 80% (doors and windows are open),
there may be water condenses or dripping near the air outlet.
NOTES FOR HEATING FUNCTION
• When the heating function is started, the indoor unit fan will not work immediately to avoid the introduction of
insufficiently hot air into the environment.
• When the outdoor temperature is very low and the humidity is high, ice may form on the heat exchanger of the
outdoor unit. Then the air conditioner will start defrost function.
• During defrost, the air conditioner will stop heating for about 5-12 minutes.
• Vapor may come out from the outdoor unit during defrost. This is not a malfunction, but a result of fast defrost.
• Heating will resume after defrost is complete.
NOTES FOR TURNING OFF
• When the air conditioner is turned off, the unit may continue to ventilate for a few minutes to help dry the battery
of the indoor unit.
EMERGENCY OPERATION
• If the remote control is faulty, use the emergency button located under the front
panel of the indoor unit (see image).
• If this button is pushed with the unit OFF, the air conditioner will operate in Auto
mode.
• If this button is pushed with the unit ON, the air conditioner will stop running.
AIRFLOW DIRECTION ADJUSTMENT
1. Use the vertical oscillation button on the remote control to set the direction of
the air flow.
2. It is possible to direct the air flow also horizontally; this operation is only
possible manually, by moving the air delivery flaps as desired (see image).
Note: move the air flaps before the unit is in operation, or your finger might be
injured.
Never place your hand into the air inlet or outlet when the air conditioner is in
operation.
V 11/23
NOTICES FOR USAGE
Emergency
button
36