Agilent Technologies Turbo-V 700 ICE Mode D'emploi page 243

17
Technical Information
Use
If necessary press CYCLE NUMBER to select YES or NO.
The controller is factory set to NO.
Enter the selection by pressing the PUMP CURRENT push-button,
and the display shows:
F R O N T / R E M O T E / S E R
S E L E C T I O N : X X X X X X
Figure 26
where: XXXXXX = means the word FRONT. REMOTE, or SER
depending on the last selection.
The controller is factory-set for FRONT panel operation. SER will
only be displayed if the optional serial card is installed.
Turbo-V 700 ICE Controller User Manual / 87-900-904-01 (L) 243/262