Agilent Technologies Turbo-V 700 ICE Mode D'emploi page 238

17 Technical Information
Use
Front / Remote / Serial Selection
Press CYCLE NUMBER and PUMP CURRENT push buttons together
for at least 2 seconds and the processor enters a routine where it is
possible to program the controller.
In this routine, the CYCLE push-button is used for choosing/changing
the value or condition; the PUMP CURRENT push-button is used to
enter and confirm the value.
At any time it is possible to exit this routine by pressing the CYCLE
and PUMP CURRENT pushbuttons at the same time for at least 2
seconds.
The display shows:
C
S
H
S
Where:
Confirm the flashing digit by pressing the PUMP CURRENT key.
L
S
238/262
O N F I G
O F T W A
Q E X X
I G H S
E T T I N
XX = 24 ÷ 42 KRPM
O W S
E T T I N
Turbo-V 700 ICE Controller User Manual / 87-900-904-01 (L)
U R A T I
R E V E
X X X X X
P E E D
G : X X
P E E D
G : X X
O N
R S I O N
X X
K R P M
K R P M