Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
en-us
FAQ
Demo Mode
If š" ‹¯ is displayed, demo mode has been activated.
The appliance will not heat up. Disconnect the appliance
from the power supply. Wait 30 seconds before
reconnecting it. Then deactivate the demo mode within
three minutes as follows:
1.
Turn the control knob anti-clockwise to the
Ž position.
2.
Turn the control knob clockwise to position 1.
3.
Turn the control knob anti-clockwise to position 0.
The illuminated ring around the control knob will be lit
yellow.
4.
Turn the control knob clockwise to position 1. The ‹¯
display will be lit and the illuminated ring will be
green.
Wait for five seconds. The ‹"" display will be lit and
the illuminated ring will turn yellow.
Demo mode has now been deactivated.
Suitability test of cookware
This function can be used to check the speed and quality
of the cooking process depending on the cookware.
The result is a reference value and depends on the
properties of the cookware and the element being used.
1.
Fill the pan with approx. 8 oz. (200 ml) water and place
it in the middle at room temperature.
2.
Go to the basic settings, and select the ™„ setting.
The ‹"" indicator lights up.
Touch the @ or A symbol. The ‹¯ display will be lit.
3.
An audible signal will sound and the burner indicator
will be lit.
The function has now been activated.
The ¥—¯ display will be lit. After a few seconds, the
burner display will show the results for the quality and
speed of the cooking process.
32
Check the result using the table below:
Result
‹
The cookware is not suitable for the element and
will therefore not heat up.*
‚
The cookware is taking longer to heat up than
expected and the cooking process is not going as
well as it ought to.*
ƒ
The cookware is heating up correctly and cooking
is progressing well.
* If there is a smaller element available, try the cookware
again on the smaller element.
To activate the function again, touch the @ or A symbol.
Notes
Do not use the wok or wok accessories with this
▯
function.
If the diameter of the burner that is used is much
▯
smaller than the diameter of the cookware, only the
middle of the cookware can be expected to heat up.
This may result in the cooking results not being as
good as expected or being less than satisfactory.
You can find information about this function in section
▯
~ "Basic settings"
You can find information about the type, size, and
▯
positioning of the cookware in the section
~ "Cooking with Induction"
Publicité
Chapitres
Table des Matières
