LAVAZZA MilkUp Mode D'emploi page 17

To froth milk, fill the container up to the 120 ml
• mark under the MAX level
To heat up and blend the milk, fill the container up
to the 180 ml
• mark above the MAX level
SELECTION OF ACCESSORIES
• To heat and froth the milk at the same time, use
only the notched crown.
• To heat the milk and blend (e.g.. hot chocolate),
adjust the notched crown inside the smooth
crown, place them in the container making sure
that the smooth crown is facing down.
Do not use the milk frother without inserting the
supplied crowns.
HEAT AND FROTH MILK
Place the container on the base, making sure it is
positioned correctly.
Remove the lid from the milk container.
Insert the chosen crown onto the pin rising up from
the assembly in the base of the container
Notched crown (to froth milk)
Smooth crown (to heat and blend)
USE OF THE MILK FROTHER
Pour the milk into the container. Refer to chapter
"FILLING AMOUNT".
Place the lid on the container.
Press the multifunction button.
The lid must always be inserted during operation.
Do not remove the milk container until the cycle
has been completed.
The appliance emits a beep.
The multifunction button switches on with a flash-
ing white light.
The appliance starts the heating cycle.
The heating process ends automatically when the
milk is sufficiently hot.
The appliance emits a double beep to indicate the
end of the heating process.
The multifunction button turns off.
Remove the hot container only by the
EN
handle.