LAVAZZA MilkUp Mode D'emploi page 16

EN
No liability is held for damage caused by:
• incorrect use not in accordance with the
intended purposes;
• repairs not carried out by authorized service
centres;
• tampering with the power supply cable;
• tampering with any parts of the appliance;
• the use of non-original spare parts and acces-
sories;
• storage at temperatures below 4°C;
• use in places with temperature below 10°C or
above 40°C;
• use in places with relative humidity above 95%;
In these cases, the warranty is not valid.
Remove any packaging materials and check that
all components are present. Before the appliance
is used for the first time, or after extended periods
of non-use, it should be thoroughly cleaned as de-
scribed in the section "MAINTENANCE AND
CLEANING".
This appliance can only be operated with original
accessories provided by the manufacturer. No lia-
bility will be assumed for any damage caused by
misuse of the milk frother or non-compliance with
the instructions contained in this manual.
STARTING THE MILK FROTHER
Position the appliance on a stable, flat surface,
away from water and heat sources. The appliance
should only be connected to an earthed sock-
et installed in accordance with the regulations.
Make sure that the supply voltage corresponds
with the voltage marked on the rating label of the
appliance. This product complies with all binding
CE labelling directives.
The first time you use the milk frother, remove all
cardboard and plastic packaging. Lift the milk con-
tainer (1) and remove the protective ring (2) locat-
ed inside the base. Place the container on the base.
PREPARATION OF THE MILK FROTHER
1
2
This appliance has only been designed to heat
and froth milk and prepare hot chocolate. Do not
put any other types of liquid or solid substances
in the container, other than those indicated by
Lavazza. Do not leave the milk frother unguard-
ed when operating. Do not leave the milk frother
unattended when in use.
To get the best results, use cold milk from the
fridge.
Make sure that the bottom of the container and
the contact area inside the base are clean and dry.
FILLING AMOUNT
Always respect the MIN and MAX level marked
inside the container.
Do not operate the milk frother with an empty
container or with a quantity of milk below the
MIN level (60 ml). This can cause the appliance
to overheat. In case of overheating, the appliance
will automatically turn off. Do not fill the contain-
er over the MAX level, it may cause hot milk to
splash.