Mach BB300 Mode D'emploi page 54

MACH
10.6 Counterweight hide-stick mode
Counterweight Hidden-Stick mode is only available in ALU-S mode, this mode can split this position into two parts and make
these two new positions hide behind the spoke.
In 10.3 operation process, if outside counterweight not hide behind the spoke, but you still want it hide behind the spoke, you
can follow below operation:
1. Press a+ key, back to figure 7-1 interface, press D key and OPT key, display input numbers of spoke(figure 10-13),press
b+ or b- key input spoke numbers, press D key and OPT key to save and return, slowly turn the wheel, turn the near by
imbalance position of spoke on the top(12 o'clock),press D and OPT key to enter hide stick mode, and then press D and
OPT key to exit.
10.6.1 Split manual stick operation
2. Stick inside operation 10.3, step 3.
3. Slowly spin wheel, when outside counterweight position indicator light (figure 5-1(9)) all on, stick counterweight on 12
o'clock position outside of rim, ect figure 10-10 right side.
4. Slowly spin wheel again, when outside counterweight position indicator light (figure 5-1(9)) all on, find second position,
stick counterweight on 12 o'clock position outside of rim, ect figure 10-10 right side.
10.6.2 Split automatic stick operation
4. When stick inside, operation same as chapter 10.3.2, steps 3 and 4.
5. Slowly spin wheel, when outside counterweight position indicator light (figure 5-1(9)) all on, find first position, draught
scale, when outside counterweight position indicator light (figure 5-1 (4)) all on, turn scale, stick counterweight on rim (see
figure 10-11).
6. Slowly spin wheel, when outside counterweight position indicator light (figure 5-1(9)) all on, find second position, draught
scale, when outside counterweight position indicator light (figure 5-1 (4)) all on, turn scale, stick counterweight on rim (see
figure 10-11)
WARNING! When use scale to stick counterweight automatically, make sure LED must
display - - -, if not, do not move scale, press STOP and ALU key, then middle LED display - - -,
now you can move scale to stick up.
10.7 Recalculation
Before wheel balance testing, sometimes may forget input current date of rim, you can after wheel balance testing input date
of rim reintroduce, at this time do not need press START key, just press recalculation key (C) system will follow new date of rim
calculation imbalance measure. Even interface currently display imbalance value, press C key, can be check currently input date
of rim.
Fig. 10-13
54
BB200 - NLFREN - v1.0 - 22112016
EN