Mach BB300 Mode D'emploi page 51

BB200 - NLFREN - v1.0 - 22112016
EN
10 Balancing operation of wheel
10.1 Balance mode change operation
1. Dynamic and static balance mode switch: press F key.
Dynamic balance mode: clip counterweight on inside and outside edge of rim (balancer tolerant normal balance mode),
ect figure 10-1.
ST mode: static balance measure mode, stick counterweight on middle of rim, ect figure 10-2.
2. ALU balance mode switch key (ALU key), switch CPU system between ALU-S~ ALU-3 mode.
ALU-S mode: stick counterweight on inside and outside of spoke of rim, ect fig. 10-3.
ALU-1 mode: stick counterweight on inside edge of rim, stick counterweight on outside (inside of spoke), etc figure 10-4.
ALU-2 mode: clip counterweight on inside edge of rim, stick counterweight on
ALU-2 mode: clip counterweight on inside edge of rim, stick counterweight on outside (inside of spoke), etc figure 10-5.
ALU-3 mode: clip counterweight on inside edge of rim, stick counterweight on
ALU-3 mode: clip counterweight on inside edge of rim, stick counterweight on outside (outside of spoke), etc figure 10-6.
Counterweight split and hidden-stick mode:
Counterweight split and Hidden-Stick Mode:
In ALU-S mode, if the outside (inside of spoke) counterweight position between of two spokes, ALU-S mode can split the
ALU-S mode, if the outside (inside of spoke) counterweight position between of
counterweight for two. The divided counterweight, just place on the back of two spokes near the former counterweight, in
order to hide the counterweight, ect figure 10-7.
10.2 Normal balance mode operation process
10.2.1 Follow figure 7.2 input date of rim.
10.2.2 Lay down protect hood and press START key, wheel spin, after stop two
10.2.3 Slowly spin wheel, when inside counterweight position indicator light(figure
Fig. 10-1
Fig. 10-3
Figure 10-5
Fig. 10-5
outside (inside of spoke), etc figure 10-5.
outside (outside of spoke), etc figure 10-6.
two spokes, ALU-S mode can split the counterweight for two. The divided
counterweight, just place on the back of two spokes near the former
counterweight, in order to hide the counterweight ect figure 10-7.
side LED display wheel both side imbalance weight, when middle LED display
OPT, can choice imbalance optimize;
5-1(8)) all on, clip correspond counterweight on 12 o'clock position on inside
Figure 10-7
Fig. 10-7
51
MACH
Fig. 10-2
Fig. 10-4
Figure 10-6
Fig. 10-6