Mach BB300 Mode D'emploi page 44

2. Automatic measure scale.
3. Testing speed and positioning system consists of gear and opto-electronic
MACH
coupler.
4. Two-phase asynchronous motor supplies and control circuit.
5. Horizontal and vertical pressure sensor.
6. Hood protection.
Measure
scale
Key board
Motor supply
and control
circuit
4. Installation of Dynamic Balancer
4 Installation
4.1 Opening and Checking
Open the package and check whether there are damaged parts. If there are some
4.1 Opening and checking
problems, please do not use the equipment and contact with the supplier. Standard
Open the package and check whether there are damaged parts. If there are some problems, please do not use the equipment
accessories with equipment are shown as follow:
and contact with the supplier. Standard accessories with equipment are shown as follow:
Screw stud of drive shaft
• 1 screw stud of drive axis
Balancing pliers
• 1 balancing pliers
Allen wrench
• 1 Allen wrench
Measure caliper
• 1 measure caliper
Locking nut
• 1 locking nut
• 4 cones Adapter (cone)
• 1 100 g counterweight
Counterweight (100g)
• 1 protection hood
Protection hood (optional) 1
4.2 Installing machine
4.2 Installation
4.2.1The balancer must be installed on the solid cement or similar ground,
• The balancer must be installed on the solid cement or similar ground, unsolidified ground can bring measuring errors.
unsolidified ground can bring measuring errors.
• There should be 50 cm around the balancer in order to operate conveniently.
4.2.2There should be 50cm around the balancer in order to operate conveniently.
• Nail anchor bolts on the base's mounting hole of balancer to fix the balancer.
4.2.3 Nail anchor bolts on the base's mounting hole of balancer to fix the balancer.
4.3 Installing hood
4.3 Protection hood
Install the frame of hood on the equipment (optional): plug the pipe of protection
hood into the hood shift (behind the cabinet), then fix with M10×65 screws.
Plug the pipe of protection hood into the hood shift (behind the cabinet), then fix with M10×65 screws.
4.4 Installing screw stud of drive shaft
Install screw stud of drive shaft on the main shaft with M10 × 150 socket bolt, then
4.4 Screw stud of drive axis
screw down the bolt. (Refer to figure 4-1)
Install screw stud of drive axis on the main axis with M10×150 socket bolt, then screw down the bolt (see figure 4-1).
2
Notice: a wheel can be installed on the main axis before screwing down, then hold the wheel by
hands in order to prevent the main axis revolving together with the bolt.
Rotating and
positioning
measure
CPU
MCU
Motor
Figure 3-1
Fig. 3-1
1
1
1
1
1
4
1
Horizontal and
vertical
pressure
Belt
44
BB200 - NLFREN - v1.0 - 22112016
Wheel hood
protection
LED
Main shaft
of balancer
EN