Mach BB300 Mode D'emploi page 53

BB200 - NLFREN - v1.0 - 22112016
EN
10.3.2 Process of automatic stickup partition counterweight
1. Follow chapter 7.3 input date of rim.
2. Lay down protect hood and press START key, wheel spinning, after stop two side LED display wheel both side imbalance
weight, when middle LED display OPT, can choice imbalance optimise.
3. If is follow figure 7-6 input date of rim, clip counterweight on inside edge of rim. Press STOP key and ALU key, all middle of
LED display - - -, stick counterweight on outside of rim.
4. If is follow 7-5 input date of rim, press STOP key and ALU key, all middle of LED display - - -,insert correspond counterweight
into the scale head slot, slowly spin wheel, when inside counterweight position indicator light (fig. 5-1(8)) all on, draught
scale, when inside counterweight position indicator light (fig. 5-1(2)) all on, slowly pull out measure scale and middle of
LED display as figure 10-10, then turn the scale, stick counterweight on the rim, ect figure 10-11.
5. Insert correspond counterweight into the scale head slot, slowly spin wheel, when outside counterweight position indicator
light (fig. 5-1(9)) all on, draught scale, when inside counterweight position indicator light (fig. 5-1 (4)) all on, turn scale,
stick counterweight on the rim, ect figure 10-11.
WARNING! When use scale to stick counterweight automatically, make sure LED must
display - - -, if not, do not move scale, press STOP and ALU key, then middle LED display - - -,
now you can move scale to stick up.
10.4 The operation process of ALU-1 to ALU-3
1. Follow 7.2 input date of rim;
2. Press ALU key, switch to correspond balance mode.
3. Lay down protect hood and press START key, wheel spinning, after stop two side LED display wheel both side imbalance
weight, when middle LED display OPT, can choice imbalance optimise.
4. Slowly spin wheel, when inside counterweight position indicator light(figure 5-1(8)) all on, follow different mode clip or stick
counterweight on 12 o'clock position inside of rim.
5. Slowly spin wheel, when outside counterweight position indicator light (figure 5-1(9)) all on, follow different mode clip or
stick counterweight on 12 o'clock position outside of rim.
10.5 Static balance (ST) operation process
1. Move measure scale to middle of rim, and measure the data of rim.
2. Press F key, switch to static balance (ST) mode.
3. Lay down protect hood and press START key, wheel spinning, after stop middle LED display wheel static imbalance weight,
when middle LED display OPT, can choice imbalance optimise.
4. Slowly spin wheel, when both side counterweight position indicator light (figure 5-1(8), (9)) all on, stick counterweight on
12 o'clock position middle of rim, ect figure 10-12.
Fig. 10-11
Fig. 10-12
53
MACH