IPC 664 Manuel D'instructions page 22

CONTROL PANEL DISPLAY CODES:
Safety code
C22
C14
FS0
SP1
Yellow led lit
Red led flashes
P1.X
P2.X
SF.X
X = A VALUE FROM "0" TO "9"
PROGRAMMING:
Your machine is factory programmed for optimum performance. It does not require further programming. However, if
you encounter one of the following codes; P1.x, P2.x or SF.x (x= a value from 0 to 9), use the following programming
instructions to reset your display. Operating the machine in a setting other than the factory setting may cause machine
failure. Machine damage due to improper programming will void your warranty.
PROGRAMMING INSTRUCTIONS:
If your display reads P1.0 , P2.1 or SF.3 simply turn the main power off and back on again to reset display (these are
the factory programmed settings). If your display reads a value greater than stated above (ex. P1."5" , P2."7" , SF."9")
continue to follow the instructions as described below.
To reprogram the machine to the factory settings, turn the main power ON and press and hold the display switch
button (battery/time symbols) down for at least 3 seconds. P1.x will appear on the display. The P1 value should read
"0" (ex. P1.0). If the value is greater than "0", press the vacuum fan button until the display reads P1.0. Press the
display switch button again to advance to the next code. The P2.x value should read "1" (ex. P2.1). Press the vacuum
fan button to properly set. Press the display switch one more time to advance to the last code. This code should read
SF.3. If the value is not "3", press the filter shaker button until the display reads SF.3. To exist the programming mode,
turn machine off.
ENGLISH (Translation of original instructions)
Cause
Short circuit brush protection:
stops all functions
Dissipater at high
temperature. Activates if
temperature is over 194° F
Worn brushes
BRUSHES KO
Battery in reserve
Battery discharged
Sweeping mode 1 button
programming activated
Sweeping mode 2 button
programming activated
Filter shaker program
setting activated
Actions to take
Reset by turning OFF the
machine and starting again
The machine resets when
temperature lowers under 176° F
Replace brush
Error can only be reset by turning off the
machine.This alarm condition arises if
the brushes are put in SHUTDOWN
condition three times in a minute.
Machine continues to work.
Only a warning that the battery
is near discharge
Machine stops all functions
Turn off machine and charge
the battery
See programming
See programming
See programming
9