EUROM PD2100XXL Mode D'emploi page 18

Step 6: Next connect the plug that comes out
from the 'head' of the radiator to the socket.
Make this connection secure using the
protective box.
Step 7: Now place the 'head' of the radiator on/in
the highest stand, in such a way that the small
screw holes beneath the radiator head lie directly
over the screw holes at the top of the highest stand
and screw the head and stand together firmly using
2x8mm screws. The electrical cable and connection
are now located in the stand.
Step 8: You can now set the height of your terrace
radiator by loosening the coupling nut a little, pulling
out the highest stand a little or letting it drop and
then fastening the coupling nut again at the desired
height.
Step 9: Now pull the underside of the excess cable
from the stand and secure the electrical cable using
two cable clamps and four 15mm screws beneath
the base. In doing this, ensure that the cable in the
Ready!
Warning! Do not connect the terrace radiator to the mains if you observe any
damage (whether to the radiator, cable or plug), and do not connect it before you
have fully assembled it!
18
stand is not
current. Allow the cable
sufficient space so that
the device can
placed in the highest
position, but
excess cable
stand.
under
be
avoid
in the