Teac TASCAM DR-10C Mode D'emploi page 15

Playback and searching
backward/forward
The Home Screen shown below appears after the
unit starts up.
8 Starting and stopping playback
When the Home Screen is open and playback
is stopped, press the 7'9 [ENTER] button to
start playback. Press this button again to stop
playback.
8 Searching backward and forward
During playback, press and hold the . [j] or
/ [k] button to start searching backward or
forward. Continue pressing and holding the .
[j] or / [k] button to accelerate the search
speed.
Release the . [j] or / [k] button to
resume playback.
The display appears as below when playback starts
and during playback.
When playback
starts
During playback
1 Recorder operation status
2 Playback file name
3 Remaining battery charge
4 Elapsed playback time
NOTE
• During playback, press and hold the MENU
button to show the remaining time of the
playing file.
• When searching, "g g" or "t t" will be shown. If
the search speed is increased, this will change
to "ggg" or "ttt".
Checking the remaining
recording capacity of the
microSD card
When stopped or recording, press and hold the
MENU button to show the remaining recording
capacity of the microSD.
Using infrared transmission
When using more than one DR-10C at the same
time, you can use infrared transmission to copy the
settings of the first DR-10C to the other ones.
NOTE
The file name set with the Menu Screen
item is not copied.
NAME
When using more than one of these units, the
setting can be set in advance to
FILE NAME
identify which units were used to record files.
For this reason, the file name set with
is not copied.
NAME
Example: set differently to identify
FILE NAME
each unit
DR-10C
1st unit DR0001 000_DR0001.wav
2nd unit DR0002 000_DR0002.wav
3rd unit DR0003 000_DR0003.wav
x x
10th unit DR0010 000_DR0010.wav
TASCAM DR-10C
FILE
FILE
File name
x
15