Bosch GWS Professional 6-100 E Notice Originale page 16

OBJ_BUCH-2541-001.book Page 16 Wednesday, May 13, 2015 9:28 AM
16 | English
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
Leinfelden, 04.05.2015
Noise/Vibration Information
The measured values of the machine are listed in the table on
page 258–260.
Sound emission values determined according to
EN 60745-2-3.
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60745-2-3.
Mounting and Operation
The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Grinding, preparation
Cutting, preparation
Cutting stone, brick and tiles,
preparation (recommendation)
Removing paint, preparation
Removing rust, preparation
1 609 92A 16M | (13.5.15)
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Figure
1
30°
2
3
4
5
Please observe
Bosch Power Tools
Page
261 –262
263 – 264
265 – 266
267
268