Publicité
Les langues disponibles
Les langues disponibles
Maintenance Instructions
Frequently clean the hood and grease filters by following the instructions below. Reinstall the grease filters
IMPORTANT:
before operating the hood.
External surfaces
To avoid damaging the outer surface, do not use steel wool pads or scouring pads. Always wipe dry the surface to avoid
leaving water marks.
Cleaning method
•
Use liquid detergent or soap or all-purpose cleaner.
•
Scrub with a soft, damp cloth or non-abrasive sponge then rinse with clear water and wipe dry.
Metal grease filter
The filters should be washed frequently. First, turn off the fan and lights. Let the LED lamp cool.
Place the metal filters in a hot detergent solution. Allow the filters to dry completely before reinstalling.
1. Remove each filter by pulling the spring handle, then pulling the filter downward.
2. Wash metal filters as needed in dishwasher (NOT RECOMMENDED) or hot detergent solution.
3. Reinstall the filter, ensuring that the spring handles are facing forward. Insert the metal grease filter in the
upper groove.
4. Pull down the handle spring.
5. Push the metal filter upwards and release the handle to encase it.
6. Repeat steps 1 to 5 for the other filter.
Replacing an LED lamp
Interrupt the power supply to the hood; wait for the LED lamps to cool. To prevent damage or avoid reducing the life of the
new bulb, do not touch the bulb with bare fingers. Replace the bulb by manipulating with a tissue paper or cotton gloves.
If the new lights do not work, ensure that each lamp is properly inserted into its socket before requesting the intervention
of a service agent.
1
Disconnect the power supply.
.
2. Use a flat-blade screwdriver, remove the bulb with care.
3. Remove the lamp. Install a new LED lamp of 120 V / 40 W maximum with a G-9 type base
4. Reinstall the light cover.
5. Reconnect the power.
A
A.
Spring handle
32
.
Publicité
