Samson DK707 Manuel Du Propriétaire page 3

Mounting the Q72 to a Drum
Installing the Q72 to your drums with the
integral DMC200 mic clip is easy. Follow the
simple steps below to install the DMC200 mic
clips to your drum kit.
Place the bottom claw the under the bottom
edge of the upper drum rim, then push the
DMC200 forward until the top claw moves over
the rim and you feel it click into place.
Adjust the height of the Q72 and tighten the
upper thumbscrew in place.
Once the DMC200 clip is fixed in place and the
height is set, you can adjust the angle of the
microphone.
Note: While adjusting the angle, you will want
to place the mic in a position that is least likely
to interfere with your playing style. Because
of the Q72's supercardioid pick-up pattern,
the microphone is subject to the phenomenon
called proximity effect, slight adjustments of
the microphone position and angle can make a
big difference in sound. For further information
on positioning your microphone see the section
"Microphone Placement".
Connect the Q72 to a mixer or audio interface
using a standard XLR mic cable and dress the
wire away from your drum.
DK707 7-Piece Drum Microphone Kit