Publicité
Les langues disponibles
Les langues disponibles
B3-2—
Connect the power cable into the side
of the charging dock and plug it in.
B3-3—
To disassemble the charging dock,
grasp the side handles of the tray and
pull upward.
Installing the Storage Stand
B4
and Storing Vacuum Accessories
B4-1—
Put the storage stand on the floor, align
its connection point with the right-hand
side of the charging dock, and install
charging dock from the top down.
B4-2—
Insert the baton holder into the slot on
the storage stand until it clicks in place.
B4-3—
To remove the holder, press the clip on
the back and pull the holder upward.
B4-4—
Store all accessories.
Note:
Do not store the main unit and dustbin combo unit on
the top of the baton to prevent it from falling down.
Connecting to the App
❶ Download the app
Search "Roborock" in the App Store or Google
Play or scan the QR code to download and
install the app.
❷ Reset WiFi
a. Keep the machine upright and press
light up the screen and enter standby mode.
b. Press and hold
and
"Resetting WiFi" voice alert. The reset is
complete when the WiFi indicator flashes
slowly. The vacuum cleaner will then wait for
a connection.
Note:
If the mobile phone fails to connect to the vacuum
cleaner because your router configuration has changed or
you forget your password or for any other reasons, reset the
WiFi and add your device again.
❸ Add the Device
Open the Roborock app, tap "Scan to Connect"
or "Search for Device" on the home page, and
add the device as instructed in the app.
Notes:
• The actual process may vary due to ongoing app updates.
Follow the instructions provided in the app.
• Only 2.4 GHz WiFi is supported.
• If the vacuum cleaner waits more than half an hour for a
connection, WiFi will be automatically disabled. If you want
to reconnect, reset the WiFi before proceeding.
• During firmware updates, do not remove the main unit
from the wet and dry vacuum cleaner, otherwise the update
will fail.
Instructions for
C
Using the Wet and
Dry Vacuum Cleaner
Filling the Clean Tank
C1
Push the clean tank release button and
C1-1—
remove the tank.
C1-2—
Open the cover, fill the tank with tap
water, and then close it tightly. The water
to
level should not exceed the MAX line.
Note:
To avoid deforming the clean tank, only use cold water.
until you hear the
C1-3—
C2
C2-1—
C2-2—
C2-3—
Notes:
• The detergent cartridge requires refilling after about 20
tanks of clean water.
• Remove or empty the detergent cartridge if detergent is
deemed unnecessary.
• To prevent corrosion or damage, do not use any
disinfectant and only use detergent recommended by
Roborock.
C3
C3-1—
C3-2—
C3-3—
C4
Unlock the cleaning head and press the
button to start the vacuum cleaner.
Notes:
• The cleaning head does not work when locked. Unlock
it first.
• Press
cleaner is charging.
08
Tilt the clean tank, install the bottom in
place, and then gently push it inward to
secure it in place.
Adding Detergent
Push the detergent cartridge release
button and remove the cartridge.
Open the detergent cartridge, fill it with
detergent, and then close it tightly.
Reinstall the detergent cartridge.
Locking and Unlocking
Tap the side of the cleaning head
without the detergent cartridge, and
push the handle to lock the cleaning
head or pull the handle to unlock the
cleaning head.
Locked
Unlocked
Starting the Vacuum Cleaner
button can only start drying when the vacuum
Publicité
